RIEVTECH STUDIO SOFTWARE MANUAL The option “ Increase ” is used to set the minimum increase or decrease per each click. It should set multiple of the “ MinScale ” .If this option is not checked, it is set the value of the “ Min Scale ” by default. l Writing value change simultaneously while sliding After this option is checked, the word register which is set in the option “ Read and Write Address ” will change in realtime during sliding the slider component. If it is not checked, the value of the word register will change after the slider block is released. 4.6.10.2 Scale The settings of the “ Scale ” property TAB are referred to: Detailed manual/ Component/ Scale .
4.6.10.3 Background Graphics The settings of the “ Background Graphics ” property TAB are referred to: Detailed manual/General functions/Drawing/Graphic edit . 4.6.10.4 SliderGraphics The settings of the “ Slider Graphics ” property TAB are referred to: Detailed manual/General functions/Drawing/Graphic edit . 4.6.10.5 DynamicGraphics The settings of the “ Dynamic Graphics ” property TAB are referred to: Detailed manual/General functions/Drawing/Dynamic Graphics . 4.6.10.6 Control Settings The settings of the “ Control Settings ” property TAB are referred to: Detailed manual/General functions/Drawing/Control settings .
4.6.10.7 Display The settings of the “ Display ” property TAB are referred to: Detailed manual/General functions/Drawing/Display . 4.6.11 Moving Component You can click the menu command “ Component/Moving Component/Moving Component ” to add amoving component in your project. 276