RIEVTECH STUDIO SOFTWARE MANUAL The main window can be set here. So you can return to the main window in any configuration window by setting “ Return to the main window (HOME) ” for the “ Window Operation ” function of the Bit Set component. 4.10.2.1.7 Drop-down window If this function is checked, you can specify a window as a pull-down window, where you can put the alarm events and other related components to display. This function is valid only for the capacitive HMI device. Note: When you slidethe HMI windowto more than half the width of the window from the upper edge down during running the project, the Drop-down window will display gradually.
Similarly, when you slide to more than half the width of the window from the lower edge up, the Drop-down window will be withdrawn. 4.10.2.1.8 Clock The “ Source ” of Clock can be set “ HMI Internal Clock ” or “ External Device ” . If you select the “ HMI Internal Clock ” as the HMI clock, SRW0~7 will be used to save the time source of events, historical data, etc. If you select the “ External Device ” , the registers address can be changed. 386