RIEVTECH STUDIO SOFTWARE MANUAL After finishing setting the "Remote PLC", the local HMI can access all the registers of the "Remote PLC" which is connected to the “ Remote HMI ” . If you need to add other remote PLCs, you can add them by referring to the above. 4.10.3.2.3 Ethernet PLC The “ Ethernet PLC ” refers to the PLC which is connected with the HMI by the Ethernet communication mode. The network communication protocols which the HMI and the PLC support are used to complete the communication. After clicking the menu "Setup / Communication Settings / Remote Connection", the "Remote HMI" settings page is opened as the default.
Click the "Ethernet PLC" tab to open the "Ethernet PLC" settings page. It is shown as below. 461