RIEVTECH STUDIO SOFTWARE MANUAL You need to check the option “ Use Dynamic Graphics ” in the property TAB of “ Dynamic Graphics ” if you want to use the dynamic graphics function. ② Control Address The start address of the control registers is selected here. The start control register address editing is referred to: Detailed manual/General function/Address editor/Standard ByteAddress Input . ③ Control Position The option of "Control Position" needs to be checked if you want to adjust the position of the component dynamically.Two registers are used.
The addresses will be set and displayed automatically after the “ Control Address ” is given.These two registers will control the absolute coordinates of the fixed point of the component on the screen window. The touch screen coordinate system is referred to: Detailed manual/General function/Drawing/Position . ④ Control Size The option of "Control Size" needs to be checked if you want to adjust the size of the component dynamically.Two registers are used. The addresses will be set and displayed automatically after the “ Control Address ” is given.These two registers will control the width and the height of the component.
The register to control the width is valid for the components which the width and the height are equal, such as the square and the circle. ⑤ Control Rotating The option of "Control Rotating" needs to be checked if you want to adjust the rotation angle of the component dynamically. One registers is used. The address will be set and displayed automatically after the “ Control Address ” is given.The register will control the clockwise rotation angle of the component.This angle range is 0-360degrees. Note: The position, size, and rotating controlare based on the "fixed point" of the component. The fixed point is referred to: Detailed manual/General function/Drawing/Rotation .
4.13.15 Table Drawing You can find the property TAB “ Table ” . 539