A message dialog informs you of the status of the change, and whether there is any affect on operations such as a restart or a time delay before the change takes effect. 3.6 Configure the Fleet Interface Network Settings To configure the Fleet Interface, you require: l A dedicated static IP address to assign to the Fleet Interface port. This IP is allowed, but not required, to be on the same subnet as the Management IP. Do not use 1.2.3.4, because that address is permanently assigned to the Maintenance Ethernet port. l The subnet mask for the network that your Fleet will use. l The IP address of the network Gateway. Configure the Fleet Interface network connections as follows: 1.
In the SetNetGo web interface, click the Network Tab . 2. Click Fleet Interface and enter the: a. IP address. b. Subnet mask. c. Network Gateway IP address (typically a router). 3. Click Apply . A message dialog informs you of the status of the change, and whether there is any affect on operations such as a restart or a time delay before the change takes effect. 20569-020 Rev. A Fleet Operations Workspace Core User's Guide 25