Chapter 3: Fleet Manager Configuration and Operation 6. From the drop-down menu next to the Pairing Role, select Primary , and click Apply . 7. Enter the IP Address of the Secondary appliance. Click Apply . 8. You will get a message to confirm changes, saying that ARAMCentral will restart, dis- connecting AMRs and clients. Click OK . 9. You will get a confirmation message that the changes were successfully applied. Click OK . 10. Click Generate New Key to create an SSL key, or Download Existing Key , if you pre- viously created an SSL key. Uploading the SSL key to the Secondary appliance grants permission for the Primary to perform RPC calls required for synchronization. 11.
You are prompted for a location to save the key file. Enter a location (path) where you want to save the file on your PC, so you can later upload it to the Secondary appli- ance. 12. A warning message indicates the pending disconnection of AMRs and clients. Click Your Primary Fleet Manager is now configured to run as part of a pair. OK . Configure the Secondary Appliance Do this only if you have two Fleet Manager appliances, and you want to configure one as a Secondary Autosync appliance. You must first: 1. In the SetNetGo web interface, click System tab, then Mode . 2. From the drop-down menu choose Paired Fleet Manager and click Apply . 3.
You will get a "Confirm Appliance Mode Change" pop-up message. Click OK . 4. You will get a second pop-up with a warning message that this operation will interrupt the fleet management. Click OK . 5. A Pairing selection will appear in the left margin of the screen. Click on Pairing. 28 Fleet Operations Workspace Core User's Guide 20569-020 Rev. A