Chapter 3: Fleet Manager Configuration and Operation 30 Fleet Operations Workspace Core User's Guide 20569-020 Rev. A 2. Open the Config tab. 3. Check Show Expert Parameters to show the advanced configuration parameters. 4. From MobilePlanner, Config select Fleet and then Fleet Manager Connection. Figure 3-5. Fleet Manager Connection Screen 5. Check the ConnectToFleetManager checkbox. 6. Enter the IP address of the EM2100 appliance in the FleetManagerAddress field. NOTE: This is the Fleet IP address, not the Management IP address of the EM2100. 7. Enter an identifier in the Identifier field. You must use unique identifiers for each AMR. Do not change this identifier after initial setup.
Repeat these steps for each AMR that you want to add to the fleet controlled by this EM2100 Fleet Manager. eet-Level Settings From MobilePlanner, Config, on the Fleet Manager: 1. Select Fleet and then Fleet Features. 2. Check the FleetManagerGatherScans box. This enables Fleet Operations Workspace Core to gather any scan files created by the AMRs. 3. Back up (copy) any required maps to a storage location.