When the Device Check ends, touch "Next" on the screen or press the Part Balance [Accomp] button to go to the next test. DEVICE CONTENTS PROGRAM ROM checks the Checksum DRAM checks the working of the DRAM for CPU Wave rom checks the Checksum DSP RAM checks the RAM for XPDSP ESP RAM checks the RAM for ESP DATA ROM checks the Checksum DATA ROM TYPE checks the type of DATA ROM FDC Ex Port checks the FDC port The devices and contents checked are as follows: When no problem is found, "OK" will be shown on the top of the display. On the contrary, the following error message will appear: Note: After the calibration, turn down the general volume so as to avoid hearing the audio noise.
This control starts automatically after the calibration step. The display may change as follows: 2. Display of the Device Check and Rom Version You have to carry out the calibration again. Press the Part Balance [Accomp] button to go to the next test. Note: The calibration set will be memorized at the point " 3 " Factory Preset Setting" of the Test mode. When the calibration fails, the following display will appear: 18 E-600 July, 1999 Once the check ends, touch [Next] on the screen or press Part Balance [Accomp] to go on in the test mode.
BUTTON OUTPUT Pop Sound PIANO 1 Direct sound Piano Style PIANO 1 CHORUS sound Ballad PIANO 1 REVERB sound Rock PIANO 1 RESONANCE sound Oldies Sine wave from the LEFT speaker. Country Square wave from the RIGHT speaker. Band/Swing Sine wave from both speakers. Press the following buttons to check the effects and the pannings: The following display will appear: 5. Speaker Panning and Effect Sound check. A piano sound should be heard and the LED corresponding to each pressed button turns off. When you press the [Metronome], [Song] and [Page] buttons, the Beat indicators turn off. When you press the buttons without LEDs the relative name indicated on the LCD disappears. NOTE:
If you press the Part Balance [Accomp]button first, you will go on to the following test. Once you begin the checking process for this kind of test, it is not possible to go to the following one before checking all the buttons. Press the Part Balance [Accomp] button in the end and you will go on to the following test. All the LEDs light up and the following display appears: 4. Buttons and LEDs check Touch "Go" on the screen or press Part Balance [Accomp] to start the loading of the Factory Preset Setting in the internal memory. For not loading the Factory preset setting in the memory, touch "Skip" on the screen. The following display will appear: 3. Factory Preset Setting