Specifications and Placing of Originals > Placing Originals > Standard Size Originals Note: When placing long receipts, refer to the section "Placing Long Paper". Related Information & “Placing Long Paper” on page 44 Basic Steps for Placing Originals 1. Extend the input tray extension. Slide out the output tray, extend the output tray extension, and then raise the stopper. Note: ❏ For A4 size or larger originals, make sure you pull out and extend the input tray extension.
❏ Make sure you pull out and extend the output tray extensions so that they are a little bit longer than the length of the original, and raise the stopper so that the ejected originals can be stacked comfortably on the output tray. ❏ The stopper can move forward and backward on the output tray extension so that you can easily adjust the stopper position to the best position for the originals being scanned. ❏ If thick originals bump into the output tray and fall from it, store the output tray and do not use it to stack the ejected originals.
❏ If scanned images are still affected by ejected originals hitting the surface below the scanner, we recommend placing the scanner on the edge of a table where the ejected originals can drop freely and you can catch them. 40 Size Resolution Loading Capacity Up to 215.9×393.8 mm (8.5×15.5 in.) 301 dpi or more Thickness of the originals stack: under 12 mm (0.47 in.) The loading capacity varies depending on the receipt. Up to 79×660 mm (3.14×26 in.) at a width of 79 mm (3.14 in.) or less 300 dpi or less Up to 215.9×914.4 mm (8.5×36 in.) at a width of 80 mm (3.15 in.) or more