SAMI G S 9.1.3 Group 13 - Ref Value Scaling These values can be altered with the SAMI GS running. Max 120 Hz *) Max value is set automatically according to the setting of parameter 22.4. para. 13.2 0Hz para. 13.1 Note! If max./min. frequency setting is changed (para. 22.1, 22.2), the setting of parameters 13.1 and 13.2 changes accord- ingly. Parameter 13.3 and 13.4 are not available with Macros PI- or PFC-Control. Min Ext ref1 f out Figure 9-3. External Reference scaling. 9.1.4 Group 14 - Output Signals These values can only be altered when SAMI GS is stopped.
1 Analogue Out 1 OUT CUR = Output current This parameter allows you to select which output signal is connected to Analogue Output 1 (current signal).
MOT TORQ = Motor torque MOT POWER = Motor power V/DC-LINK = DC-link voltage NOT USED OUT FREQ = Output frequency MOT VOLT = Motor voltage MOT SPEED = Motor speed 42 Parameter Range/Unit Description 1 Ext Ref1 Min Scale 2 Ext Ref1 Max Scale 3 Ext Ref2 Min Scale 4 Ext Ref2 Max Scale 0...120/500 Hz *) 0...120/500 Hz*) 0...120/500 Hz *) 0...120/500 Hz *) External reference 1 minimum value Cannot be set > Ext Ref1 Max Scale External reference 1 maximum value Cannot be set Ext Ref2 Max Scale External reference 2 maximum value Cannot be set Parameter Range/Unit Description 1 Analogue Out 1 2 Analogue Out 2 3 Relay RO1 Out 4 Relay RO2 Out 5 Relay RO3 Out Refer to the text below for the available selections Analogue Output 1 content Analogue Output 2 content Relay Output 1 content Relay Output 2 content Relay Output 3 content