SC-B9580 User's Guide Basic Operations See the following table for more details on A to H . *1 The set margin and the actual print results may differ depending on the RIP being used. Contact the RIP manufacturer for more information. *2 With Width Adjustment in the settings menu for the printer, you can adjust the margins in a range between -10 mm and +10 mm (-0.39 in. and 0.39 in.). *3 This may be available in the RIP depending on the RIP software being used. Contact the RIP manufacturer for more information. 56 Position Explanation Available Setting Range A Trailing edge *1, *3 Half the value selected for Margin Between Pages in the printer's settings menu.
To maintain media feeding accuracy, if the settings are less than 10 mm (0.39 in.), the settings are switched to 5 mm (0.19 in.). 0 to 999 mm (0 to 39.33 in.) (Setting for Margin Between Pages) B Leading edge *1, *2, *3 Half the value selected for Margin Between Pages. If the settings are less than 10 mm (0.39 in.), the settings are switched to “the setting -5.” If Skip Wrinkled Media is On, the leading edge margins will not be smaller than the Skip Wrinkled Media setting. Therefore, if the setting for Margin Between Pages is less than twice the Skip Wrinkled Media setting, a leading edge margin equal to the Skip Wrinkled Media setting is created.
C Right edge *3, *4 The total of the values selected for Print Start Position and Side (Right). The default setting for Print Start Position is 0 mm and Side (Right) is 5 mm (0.19 in.). When media edge plates are used, a value to which 5 mm (0.19 in.) is added is applied as the actual margin since within 5 mm (0.19 in.) of the edge is recognized as the media edge. 3 to 1025 mm (0.11 to 40.35 in.) D Left edge *3, *4 The value selected for Side (Left). The default setting is 5 mm (0.19 in.). When media edge plates are used, a value to which 5 mm (0.19 in.) is added is applied as the actual margin since within 5 mm (0.19 in.) of the edge is recognized as the media edge.
3 to 25 mm (0.11 to 0.98 in.) E Nozzle check pattern printing width 16 mm (0.62 in.) when Normal is selected in Pattern Selection. 4 mm (0.15 in.) when Paper Width Saving is selected. - F Space between nozzle check patterns and Event Marking Fixed to 3 mm (0.11 in.). - G Event Marking width Fixed to 20 mm (0.78 in.). - H Space between nozzle check patterns / Event Marking and image When Print Position is set to Next to the Image, the margin on the right side of the image represents the value selected for Margin Between Images. When it is set to Media End, the value varies according to images and other settings. 0 to 999 mm (0 to 39.33 in.)