SC-T7630D/SC-T5630DM User's Guide Introduction Notes on Usage and Storage Notes when using the printer Note the following points when using this printer to avoid breakdowns, malfunctions, and print quality decline. Installation space ❏ When using the printer, observe the operating temperature and humidity range described in the "Specifications Table". U “Specifications Table” on page 197 Even when the conditions above are met, you may not be able to print properly if the environmental conditions are not suitable for the paper. Be sure to use the printer in an environment where the paper's requirements are met. For more details, see the documentation supplied with the paper.
Also, when operating in dry areas, air conditioned environment, or under direct sunlight, maintain the appropriate humidity. Make sure that you secure the following space, clear of any other objects, so that paper ejection and consumable replacement are not obstructed. ❏ Avoid using the printer in locations with heat sources or that are exposed to direct draughts from ventilators or air conditioners. Failure to observe this precaution could result in the print head nozzles drying and clogging. SC-T7630D ❏ The print head may not be capped (i.e., may not move to the right-hand side) if an error occurs and the printer is turned off without first resolving the error.
Capping is a function for automatically covering the print head with a cap (lid) to prevent the print head from drying out. In this case, turn on the power and wait a while until capping is performed automatically. SC-T5630DM ❏ When the power is on, do not remove the power plug or cut the power at the breaker. The print head may not be capped properly. In this case, turn on the power and wait a while until capping is performed automatically. ❏ Even when the printer is not in use, some ink will be consumed for all colors by head cleaning and other maintenance operations needed to keep the head in good condition. D1 : The space required when not using cut sheets/ poster board.
Notes when not using the printer D2 : The space required when using cut sheets/ poster board. Secure up to 1600 mm front and back plus the working space. If you are not using it, note the following points when storing the printer. If it is not stored correctly, you may not be able to print properly the next time it is used. 18 W D1 D2 1988 mm 1129 mm Secure up to 1600 mm plus the working space. The space required depends on the cut sheets/poster board being used. W D1 D2 1785 mm 1129 mm Secure up to 1600 mm plus the working space. The space required depends on the cut sheets/poster board being used.