Chapter 2: Installation Procedures F. Accessing the Hard Disk Drive Tray and Installing a Hard Drive To install a hard disk drive into the chassis, you need to fi rst remove the HDD tray from the chassis so that the HDD can be installed in. Procedures 1. Press the release tab to unlock the HDD tray. 2. Pull the HDD tray out from the chassis as shown below: 2 1 3. Remove the two screws that attach to the both sides of the dummy HDD, and take out the dummy HDD as shown below: 3b 3a 4. Slide a hard drive disk (HDD) into the HDD tray, and secure the HDD to the tray with three screws on each side of the tray as shown below: 4a 4b 5.
Once the HDD is securely placed into the HDD tray, you can install the HDD drive tray back to the chassis. 2-7