Inserting a Channel 5 Inserting a Channel In order to be able to record the variables of the software task (e.g. the PLC task) they must be described in TCatScopeView. Each variable to be displayed is assigned to a channel in the Scope View. The procedure for inserting a channel is the same as that for inserting a Scope View. The property pages for the channels are described again in what follows. General See also " Adding a Scope View - General [ } 11] " Acquisition This page is used to describe the variable that is to be recorded. To edit the values, click on "Change..." , which will open the following dialog: There are various methods of accessing a variable.
The choice is made by means of the radio buttons displayed under Reference (upper left of the dialog). Scope View 15 Version: 1.1