2 Panel Operation 2.1 Basic Operation 2.1.1 Keys’ Names and Functions of the Panel Operator The panel operator consists of display and keys. The panel operator could display status, operate the accessory functions, set parameters and monitoring the servo drive. The panel operator keys’ names and functions are shown as below: ！ Cautions Press and hold the UP and DOWN keys simultaneously to reset the servo alarm. Before resetting the servo alarm, be sure to remove the cause of the alarm, otherwise a safety accident may occur.
32 SD700 Series Servo Technical Manual Keys Functions MODE/SET key Shift the function modes Confirm parameter settings Operate the accessory functions ▲UP key Select parameters up or increase the value, switch between high, medium, and low segment values in multiple segment display parameters ▼DOWN key Select parameters down or decrease the value, switch between high, medium, and low segment values in multiple segment display parameters DATA/SHIFT key Press and hold the DATA/SHIFT key for about 1 second to enter or exit Short press to move to the left one (when flashing)