Warning Part Names/Connecting P eripheral Equipment Back side of the Dreamcast To Prevent electric shock, connect all cables to the Dreamcast before plugging power cable into outlet. Power terminal To wall outlet (AC 100 V to 120 V) Phone jack Modem Air holes Do not block. AV terminal Television Connect yellow to the video terminal. Connect white to the audio (left) terminal. Connect red to the audio (right) terminal. (Connect white to the audio terminal if your television is monaural.) Serial terminal (for possible future expandability) Power cable (supplied) Stereo AV cable (supplied) Notes␣ The supplied stereo AV cable cannot be connected to a television without an AV input terminal.
If you are using a monaural connection, change the audio setting in the Dreamcast to Mono (see page 24). AV input terminals Connecting to a TV or VCR without Audio/Video Input Terminals Connecting to a TV/Monitor and Antenna If an antenna cable is plugged into your TV (or if you have cable TV), use a Dreamcast RF unit (sold separately). Back side of the TV set (VHF 75 ohm) 1. Unplug the antenna cable from the TV, and plug it into the RF unit -ANT IN- terminal. 2. Plug the RF unit -TV OUT- cable into the TV. 3. Plug the RF unit -A/V IN- cable into the AV terminal on the back of the Dreamcast.
VHF/UHF Cable TV or VHF antenna cable RF unit -TV OUT- cable Note␣ If your television is connected to a VCR, check to see if your VCR has audio/video input terminals to which you can connect the supplied stereo AV cable. NTSC-M CH3-CH4 MODEL NO.HKT-8820 RF unit ANT. IN TV OUT Back side of the Dreamcast A/V IN 4 3 SELECT 6 RF cable To AV terminal