Using the DCS-37-2 Mount (optional) ENGLISH Place the DCS-37-2 mounting sticker in the desired location, then use a 6 mm drill bit to drill the required holes 25 mm deep and insert the wall anchors into the holes. If you plan to pass cables through the ceiling, you will also need to drill a hole for the cable channel. Note: The camera in the corresponding graphics may be different from your product, but the procedure is the same. Use the provided screws to mount the DCS-37-2 to the wall using the inner mounting holes. Guide the camera connectors through the back or side cable channel on the DCS-37-2.
Use the provided screws to mount the camera to the DCS-37-2 using the set of mounting holes marked B . Remove the cover from the camera. Use the provided screws to mount the camera to the DCS-37-2, then adjust the angle and rotation of the camera as desired using the tilt lock screw. Attach the camera cover. If you are passing the camera cables through the ceiling, place the rubber stopper into the side cable channel to seal it. D-Link DCS-4633EV Quick Installation Guide 9