Waterproofing Your Installation ENGLISH To waterproof your camera installation, follow the instructions below. Round Ethernet cable, a crimping tool, and RJ-45 plugs are required for this procedure. Place the washer around the base of the Ethernet connector as shown. Thread bare Ethernet cable through the waterproof connector as shown. Crimp an RJ-45 connector onto the end of the cable. Connect the other end of the Ethernet cable to the camera's Ethernet port. Connect the RJ-45 plug into the Ethernet connector, then screw the waterproof connector to the Ethernet connector by turning it clockwise for about a half-turn. D-Link DCS-4633EV Quick Installation Guide 11