If you are mounting the camera to the ceiling, use a flathead screwdriver to remove the plastic hole cover from the bottom of the base, then guide the cables through the bottom. ENGLISH Connect the power and Ethernet cables, or just the Ethernet cable if you are using a PoE connection. Loosen the adjustment screw on the side of the lens assembly, then re-tighten it after adjusting the lens assembly to the desired vertical angle. The camera supports from 30 ° to 90 ° of tilt. You can also adjust the pan within a -120 ° to 120 ° range by rotating it clockwise or counter-clockwise. 30 o 90 o Tilt(Total 60 o ) When you are done adjusting the camera's angle, put the inner cover back into place.
Note : The camera has a limited range of motion; if it stops when you are adjusting it, do not attempt to rotate or tilt the camera any further in that direction. 120 o 120 o Pan(Total 240 o ) Use the screws provided to mount the camera to the ceiling. Re-attach the camera cover. D-Link DCS-4633EV Quick Installation Guide 7