ATTACHING THE SHIFT ROD 1. Place the threaded end of the shift rod inside the -.q-------.-back cover plate. See figure 9. Thread rod part- way into ferrule. Shift FIGURE 9. 2. Place the speed select lever Ln sixthspeed (6) posi- _tion. See figure 10. Push the shift rod down as far as it will go, to put the gears into full forward posi- tion. Thread the shift rod in or out of the ferrule as necessary until the end of the rod lines up with the hole in the speed select lever. 3. Insert end of rod into hole in speed select lever. Secure with hairpin clip. See figure 10. pin Clip Rod FIGURE 10.
Drive Clutch Lever ATTACHING THE TRACTION DRIVE CABLE Rubber The traction drive cable is the cable which has the spring attached to one end. Attach the traction drive cable as follows. Stop_ Traction Drive Cable 1. Hook the "Z" fitting on the end of the cable into top hole inthe traction drive clutch lever (righthand side of.handle). Hook the fitting from the inside as •._-..-----shown in figure 11. "Z" Fitting Hooked in Top Hole FIGURE 11.