Generac 2700 PSI Pressure Washer 6 • Secure tray to handle with self tapping screws using a • Pinch the chemical hose and slide it into the metal clip a #2 phillips screwdriver. Ensure screws are tight but not shown in Figure 5. crushing the plastic accessory tray. Figure 5 — Slide Chemical Hose into Metal Clip • Place the handle assembly onto the handle supports connected to the main unit. Make sure the holes in the handle align with the holes on the handle supports (Figure 2). Figure 2 — Attach Handle to Base Handle Align Holes • Tilt the unit up by the handle and attach the metal clip t the rib on the center underside of the accessory tray Handle (Figure 6).
Slide the chemical hose through the metal cli Supports so that it is tight but not kinked. Figure 6 — Slide Metal Clip onto Accessory Tray Flange NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports. • Insert the “L” bolt through the hole on the left side of the handle (viewing from handle side of unit) and attach the plastic knob.Tighten the knob by hand (Figure 3). Figure 3 — Secure Handle Add Engine Oil IMPORTANT:
Any attempt to crank or start the engine before it has been properly serviced with the • Insert the carriage bolt through the right side hole from recommended oil may result in an engine failure. the outside of the unit and attach a plastic knob from the • Place pressure washer on a level surface. inside of the unit (viewing unit from the handle side). • Refer to the engine owners manual to add recommende Tighten by hand (Figure 3). oil to engine. • Insert the “J” hook into the second from the left slot in NOTE: Check oil often during engine break–in. Refer to the accessory tray (Figure 4). engine owner’s manual for recommendations.
Figure 4 — Install “J” Hook on Accessory Tray Add Gasoline WARNING! NEVER fill fuel tank indoors. NEVE fill fuel tank when engine is running or hot.Allow unit to cool for two minutes before refueling. DO NOT light a cigarette or smoke when filling the fue tank. Figure 4 — Install “J” Hook on Accessory Tray Figure 5 — Slide Chemical Hose into Metal Clip Figure 6 — Slide Metal Clip onto Accessory Tray Flange il Figure 3 — Secure Handle