SERVmCE ADJUSTMENTS ENGINE TO ADJUST CHOKE CONTROL (See Figs. 33 and 34) TO ADJUST THROTTLE CONTROL CABLE (See Fig. 33) The choke control has been preset at the factory and adjustment should not be necessary, check adjustment as '. described below before loosening cable_ If adjustment is necessary, proceed as follows: The throttle control has been preset at the factory and adjustment should notbe necessary Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows: , With engine not running, move throttle control lever to fast (,ўe_)position. With engine not running, move choke control (located on dash panel) to full choke (1",,I) position.
° Remove air cleaner cover, filter and cartridge plate to expose carburetor choke (See "AIR FILTER" in the Customer Responsibilities section of this manual). - Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely. Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw se _ curely. Reassemble air cleaner. IDLE FUEL ADJUSTING SCREW IDLE SPEED ADJUSTING SCREW CLOSED FOR FULL THROTTLE CONTROL CABLE FIG. 34 STOP SCREW CLAMP SCREW CHOKE CONTROL CABLE FIG. 33 25