.... i ................. ,,, Assembly (continued) O Assembling Table Extensions 1 From the bag labeled "Table Extensions" remove the following hardware: (Quantity indicated is for two extensions) Hex Head Screw 0 21_41,D. Flat Washer @Q *8 Hex Head Screws, 5/16-18 x 1-1/4" Long *8 Flat Washers, 21/64 x 5/8 x 1/16 5/16 In External Lockwasher © *8 Hex Nuts, 5/16-18 "10 Truss Head Screw, 1/4-20 x 1 *8 Lockwashers. 5/16" External Type 5/16-18 Hex Nut 17/64 I,D. Hex Nut Flat Washer 114 In External Lock'washer "10 Hex Nut, 1/4-20 "10 Lockwashers, 1/4 External Type *4 Flat Washers, 1/7/64 x 3/4 x 1/16 2 Brackets Truss Head Screw From the bag labeled "Large Parts" remove only the fol- lowing:
Bracket 4 Comer Support Brackets From among the loose parts find the following: 2 Table Extensions s°ppc items marked with asterisk (*) are shown actual size 2 Assemble with saw upside down NOTE: To protect the finished surfaces of the saw and extensions, lay a piece of heavy paper or cardboard on the floor.. 17/64 I.D. Flat Washer \ 1/4-20 \ Hex Nut Corner _._\ / (_ support Bracket ----__ Lockwasher Table k' _'-4z.z_ WARNING: Stock table extensions must be installed. They help support the fence guide bars. An unsupported guide bar can twist. Twisted guide bars can misalign fence. A misaligned fence can cause binding or kickback.
You could be hit or cut, 3 Install corner support brackets, 1/4-20 x 1 inch truss head screws, 17/64 inch flat washers, 1/4 inch exter- nal Iockwashers and 1/4-20 hex nuts as shown, Hand This Edge Toward Table tighten onty 4 insert four (4) 5/16-18 x 1-1/4 inch long hex head screws through the holes on inside edge of one extension 5 Instal!
21/64 ID fiat washer, 5/16 external lock- washer, and 5/16-t8 hex nut on the end of each screw Just start nut on end of screw 6 Slide the extension with hardware into four slots in side of table Line up front edge of extension with front edge of table and tighten all screws and nuts 7 Repeat for other extension 5/16-18 Hex Nut _ 51'16Lock'washer 21/64 I.D. Flat Washer Hex Head Screw t4