Motor Specifications and Electrical Requirements 1 _ower Supply and Motor Specifications The A-C motor used in this tool is a relay start, non-revers- ible type, having the following specifications: WARNING: To avoid electrical hazards, fire haz- ards or damage to the tool, use proper circuit pro- tection. Your tool is wired at the factory for operation using the voltage shown. Connect toot to a power line with the appropriate voltage and a 15-amp branch circuit. Use a 15-amp time delay type fuse or circuit breaker. To avoid shock or fire, if power cord is worn or cut, or damaged in any way, have it replaced immediately.
Rated H P 1 Voltage 110-120 Amperes 1t 5 Hertz (Cycles) 60 Phase Single RPM 3450 Rotation of Shaft Counterclockwise i ,,u .............. General Electrical Connections DANGER: To avoid electrocution: 1. Use only identical replacement parts when ser- vicing, Servicing should be performed by a qualified service technician. 2, Do not use in rain or where floor is wet. This tool is intended for indoor residential use 7 WARNING: Do not permit fingers to touch the ter- | minals of plug when installing or removing the plug to or from the outlet. ......... only. 110-120 Volt, 60 Hz. Tool Information NOTE:
The plug supplied on your toof may not fit into the outtet you are planning to use Your local electrical code may require slightly different power cord plug connec- tions if these differences exist refer to and make the If the grounding instructions are not completely under- stood, or if you are in doubt as to whether the tool is prop- erly grounded check with a qualified electrician or service )ersonnel. proper adjustments per your local code before your tool is plugged in and turned on WARNING:
If not properly grounded, this tool can cause an electrical shock, particularly when used in damp locations, in proximity to plumbing, or out of doors_ If an electrical shock occurs there is the In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock This toot is equipped with an electric cord having an equipment-grounding con- ductor and a grounding plug, as shown,, The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances potential of a secondary hazard, such as your hands contacting the sawblade.
Properly Grounded 3-Prong Outlet \ J 3-Prong Plug Do not modify the plug provided, If it will not fit the outlet, have the proper outlet installed by a qualified electrician A temporary adapter may be used to connect this plug to a 2-prong outlet as shown if a properly grounded three prong outlet is not available,.
This temporary adapter should be used only until a properly grounded three prong outlet can be installed by a qualified electrician The green colored rigid ear', lug or the like, extending from the adapter must be connected to a permanent ground such as a properly grounded outfet box In 111 G!ounding Prong Make sure this Is Connected to a Known Ground Grounding Lug _ Improper connection of the equipment-grounding con- ductor can result in a risk of electric shock The conduc- tor with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-ground- ing conductor to a live terminal 2-Prong Outlet NOTE:
The adapter illustrated is for use only if you already have a properly grounded 2-prong outlet 7