HOW TO SET UP YOUR TRACTOR INSTALL MULCHER PLATE CONNECT BATTERY Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown. NOTE: Pre-assemble weld nut to latch Lift hood to raised position. If this battery is put into service after month and year indicated on label (label located between terminals) charge bat- tery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual hook by inserting weld nut from the top with hook pointing down. Tighten hardware securely. Raise and hold deflector shield in up- right position. Place front of mulcher plate over front of mower deck opening and slide into place, as shown.
Hook front latch into hole on front of mower deck. Hook rear latch into hole on back of mower deck. _,CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching mulcher prate and allow it to rest on plate while in operation. for charging instructions). ..v ч°- . ." #o,' -. , Label Weld Nut From Hook Points The Top Down INSTALL SEAT Adjust seat before tightening adjustment knob. "-.,, Lock Weld Washer Remove cardboard packing on seat pan. Place seat on seat pan and assemble shoulder bolt. Tighten shoulder bolt securely. Assemble adjustment knob and flat washer loosely. Do not tighten. Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. Get off seat without moving its adjusted position. Raise seat and tighten adjustment knob securely. Latch Latch Hook JNut Lock Washer Washer Mulcher Plate "_..i Screw Washer Deflector Shield Seat Seat Pan Shoulder Bc_t Latch Hooks Flat Washer Adjustment Knob