SERVICE AND ADJUSTMENTS CAUTION: A: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in ='DISENGAGED" position. Turn ignition key "OFF" and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug= BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: o e e o TO REMOVE MOWER (See Fig.
18) Mowerwill be easier to remove from the right side oftractor,, CLUTCH CLUTCH LEVER Place attachment clutch in "DISENGAGED" position_ Move attachment lift lever forward to lower rnower to its lowest position,, Rotl belt off engine pulley. Disconnect clutch rod from clutch lever by removing retalner spring. Disconnect anti-sway bar from chassis bracket by removing retainer spring,. RETAINER NG ENGINE SUSPENSION ARMS ° Disconnect suspension arms from rear deck brackets by removing retainer spdngs_ Disconnect front links from deck by removing retainer springs. Raise lift lever to raise suspension arms. Slide mower out from under tractor.
IMPORTANT; IF AN ATTACHMENT OTHER THAN THE MOWER IS TO BE MOUNTED TO THE TRACTOR, THE R,H. AND LH. SUSPENSION ARMS MUST BE REMOVED FROM TRACTOR. SPRINGS SLOES) RETAINER SPRING / TO INSTALL MOWER (See Fig. 18) Raise attachment lift lever to its highest position. ANTI°SWAY BAR RETAINER SPRINGS (BOTHSIDES) Slide mower undertractor with discharge guard to right side of tractor° FIG. 18 Lower lift lever to its lowest position. Install mower in reverse order of removal instructions. 18