SERVICE AND ADJUSTMENTS TO ADJUST STEERING WHEEL ALIGNMENT TO START ENGINE WITH A WEAK BATTERY (See Fig. 27) tf steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructionsin the Assembly section of this manual CAUTION: Lead.,acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.
The front wheel toe-in and camber are not adjustable on your tractor° If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/depadmento FRONT WHEEL TOE-IN/CAMBER If your battery is too weak to start the engine, it should be recharged. If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: YOUR TRACTOR 1S EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM° THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES,, TO REMOVE WHEEL FOR REPAIRS (See Fig.
26) Block up axle securely Remove axle cover, retaining ring andwashers to allow wheel removal (rearwheel contains a square key - Do not lose). TO ATTACH JUMPER CABLES - ° Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis. = Connect one end of the BLACK cable to the NEGA- TIVE (-) terminal of fully charged battery_ ° Repair tire and reassembleo ° On rear wheels only: align grooves in rear wheel hub and axle. Insert square key ° Replace washers and snap retaining ring securely in axle groove. ° Connect the other end of the BLACK cabte to good CHASSIS GROUND, away from fuel tank and battery. Replace axle cover..
TO REMOVE CABLES, REVERSE ORDER BLACK cable first from chassis and then from the fully charged battery,, = RED cable last from both batteries.. WASHERS RETAINING RING POSITIVE TERMINAL NEGATIVE TERMINAL i AXLE COVER _ SQUARE KEY FIG. 26 (REAR WHEEL ONLY) CHARGED BATTERY POSITIVE TERMINAL NEGATIVE TERMINAL FIG. 27 21