Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY FRONT A socket wrench set will make assembly easier. Standard wrench sizes are listed. (t) Utilityknife (1) Wire cutter (1) Tire pressure gauge (1) Screwdriver (1) Pair of pliers (1) 9/16" wrench OPERATOR'S POSITION When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).
LEFT RIGHT L1 OPERATOR'S POSITION CONTENTS OF HARDWARE PACK (2) Handle Locks (1) Center Locknut 3/8-16 UNC (1) Carriage Bolt 3/8-'16 UNC x I Gr. 5 (1) Cable Clip I (2) Hairpin Clips (1) Pivot Bolt 3/8-16 UNC Grade 5 (1) Flat Washer 13/32 x I x 11 Ga. Extra Shear Pins & Clips (1) Handle Lock Lever r