Slope Sheet Keys For Future Use (2) Keys Your new tractor has been assembled at the factory. When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel). 3. Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. 4. Get off seat without moving its ad- justed position. 5. Raise seat and tighten adjustment knob securely. TO REMOVE TRACTOR FROM CARTON UNPACK CARTON 1. Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat. 2. Remove packing materials. 3.
Remove protective materials from trac- tor hood and grille. IMPORTANT: Check for and remove any staplesin skid that may puncture tires where tractor is to roll off skid. Adjustment_ Knob __ NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. HOW TO SET UP YOUR TRACTOR CHECK BATTERY TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls) 1. Lift hood to raised position. NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual for charging instruc- tions). 1. Press lift lever plunger and raise attachment lift lever to its highest po- sition. 2. Release parking brake by depressing brake pedal. 3. Place freewheel control in "trans- mission disengaged" position (See "TO TRANSPORT" in the Operation section of this manual). 4. Roll tractor forward off skid. Label TO DRIVE TRACTOR OFF SKID (See Operation section for location and function of controls) ,all'WARNING: Before starting, read, un- derstand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area.
Be sure the area in front of tractor is clear of other people and objects. ADJUST SEAT 1. Raise seat and loosen adjustment knob. , Lower seat into operating position and sit in seat. 7