ADJUSTIVIE TS .......................... SERVICE TO REPLACE BELTS The drive belts on this snow thrower are of special con- struction and should be replaced with original equipment belts available from your nearest SEARS Store or Serv- ice Center° BELT COVER / You will need the assistance of a second person while replacing the belts,, Drain the gasoline from the fuel tank by removing the fu el line. Drain the gas and reinstall fuel line,, ouT cAo,,o.: I DOORS, AWAY FROM FIRE OR FLAME I 1/4 X I12 INCH SELF TAPPING SCREW AUGER DRIVE BELT if your snow thrower will not discharge snow, and the auger drive belt is damaged, replace it as follows:
,,, ,,, ,, , Ill, FIG, 26 TRACTION DRIVE BELT Disconnect the spark plug wire° TRACK DRIVE IMPELLER PULLEY DRIVE GUIDE e Remove the belt cover (See Fig. 26) ® Loosen the belt guides (See Fig, 28) and pull away from the drive pulley° o Loosen the auger idler pulley (See Fig. 28) and slip the belt out, AUGER DRIVE BELT GUIDE PULLEY (Right BELT_ (Left Hand) e Engage the auger drive lever,, This will pull the brake assembly (See Fig, 27) away from the pulley and allow the belt to be slipped out.
AUGERIDLER PULLEY TRACK DRIVE IDLER PULLEY e Remove the belt from the auger drive engine pulley° e Install the original equipment replacement belt in reverse order of removal, Release the auger drive lever,, ® Place the drive belt onto the auger drive pulley. Adjust the drive belt (see To _djust Auger Drive Belt paragraph on page t8),, o Adjust the belt guides (see To Adjust The Belt Guides paragraph on page 20)., ® Reinstall the belt cover_ ® Check clutch control cable adjustment (see page 18),, e Reconnect the spark plug wire, 19