ASSEMBLY Jllll/lllllll I I I ill CONNECT BATTERY (See Figs. 2 and 3) CAUTION: Do not short battery termi- nals. Before connecting battery, re- move metal bracelets, wristwatch bands, rings, etc. SEAT PAN Positive terminal must be connected first to prevent sparking from acciden- tal grounding. . Remove cardboard packing from seat pan and lift seat pan to raised position. BOXDOOR o Open batterybox door. o Remove terminal protective caps and discard.
° if tilis battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 ampso = First connect RED battery cable to positive (+) terminal with hex bolt, flat washer, lock washer and hex nut as shown. Tighten securely_ = Connect BLACK grounding cableto negative (-) termi- nal with remaining hex bolt, flat washer, lock washer and flex nut° Tighten securely. FIG. 3 ° Close battery box door. INSTALL SEAT (See Fig. 4) Adjust seat before, tightening adjustment bolt. ° Remove cardboard packing on seat pan Place seat on seat pan and assemble shoulder bolt.
° Assemble adjustment bolt, lockwasherand flatwasher loosely,, Do not tighten. ° Tighten shoulder bolt securely. ° Lower seat into operating position and sit on seat. = Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all tile way down,, Get off seat without moving its adjusted position° ° Raise seat and tighten adjustment bolt securely. Open battery box door for: ° inspection for secure connections (to tighten hard- ware)° = Inspection for corrosion. ° Testing battery. ° Jumping (if required).
Periodic charging o DISCARD TERMINAL PROTECTIVE CAPS POSITIVE / SEAT (RED) CABLI_ LOCK HEX WASHER NUT FLAT WASHER SEAT PAN SHOULDER BOLT \ VENT BOLT (KEEP CLEAN) NEGATIVE "_ (BLAC_CABLE LOCK WASHER ADJUSTMENT BOLT LARGE FLATWASHER FIG. 4 FIG. 2 8