n ...................... IIIIJlH n II IIIIIII I II1'11' SERVICE AND ADJUSTMENTS i ii iii1,1 iii i ii iii1,1,1 , IIHII iii i iiii1,11111111,1,1 ii iiiiiiiii i i CAUTION: BEFORE PERFORM|NG ANY SERVICE OR ADJUSTMENTS: &: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in "DISENGAGED" position, Turn ignition key "OFF" and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plugo t TRACTOR CLUTCH LEVER TO REMOVE MOWER (See Fig.
19) Mower will be easier to remove from the right side of tractor, CLUTCH ROD RETAINER SPRING Place attachment clutch in "DISENGAGED" position, Move attachment lift lever forward to lower mower to its lowest position_ ENGINE PULLEY Roll belt off engine pulley.. SUSPENSION ARMS Disconnect clutch rod from clutch lever by removing retainer spring Disconnect anti-sway, bar from chassis bracket by removing retainer spnng_ Disconnect suspension arms from rear deck brackets by removing retainer springs, Disconnect front links from deck by removing retainer springs. Raise lift lever to raise suspension arms,. Slide mower out from under tractor, IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE MOWER IS TO BE MOUNTED TO THE TRACTOR, THE R.H. AND L,H, SUSPENSION ARMS MUST BE REMOVED FROM TRACTOR, RETAINER SPRING ANTI-SWAY BAR RETAINER SPRINGS (BOTH SIDES) TO INSTALL MOWER (See Fig. 19) RETAINER SPRINGS (BOTH SIDES) Raise attachment lift lever to its highest position, FIG, 't9 Slide mower under tractor with discharge guard to right side of tractor, Lower lift lever to its lowest position. ° Install mower in reverse order of removal instructions_ 19