Generac Portable Products 2,100 PSI High Pressure Washer Slide the nozzle forward to adjust the spray to low pressure mode (Figure 17). Slide the nozzle backward to achieve high pressure. For most effective cleaning, keep the spray nozzle between 8 to 24 inches away from cleaning surface. If you get the spray nozzle too close, especially using high pressure mode, you may damage the surface being cleaned. Do Not get closer than 8 inches when cleaning tires. Applying Detergent with the Adjustable Nozzle CAUTION! You must attach all hoses before you start the engine. Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
Point the nozzle down towards a firm surface and press the trigger to test the pattern (Figure 18). IMPORTANT: Use soaps designed specifically for pressure washers. Household detergents could damage the pump. Figure 18 — Test the Spray Pattern To apply detergent, follow these steps: Review the use of adjustable nozzles. Prepare detergent solution as required by the Twisting the nozzle adjusts the spray pattern from a narrow pattern to a fan pattern (Figure 19). Figure 19 - Adjusting Spray Pattern Place the small filter end of the detergent siphoning tube into the detergent container. CAUTION! Keep the detergent siphoning tube from coming in contact with the hot muffler.
Slide the adjustable nozzle forward to low pressure mode. Detergent cannot be applied with the nozzle in high pressure position. Twist nozzle counterclockwise for fan spray pattern. Twist nozzle clockwise for narrow spray pattern. 10 Figure 17 - Adjusting Spray Pressure Slide nozzle backward for high pressure mode. Slide nozzle forward for low pressure mode and detergent application. rer. etergent solution on the “J” hook ory tray, as shown in Figure 20. Figure 20 — Insert Filter into Container