Generac Portable Products 2,100 PSI High Pressure Washer 6 • Place the handle onto the handle supports already Figure 5 — Slide Chemical Hose into Metal Clip connected to the main unit. Make sure the holes in the handle align with the holes on the handle supports (Figure 2). Figure 2 — Attach Handle to Base Handle Align Holes • Tilt the unit up by the handle and attach the metal clip to the rib on the left underside of the accessory tray (Figure 6). Slide the chemical hose through the metal clip Handle so that it is tight but not kinked. Supports Figure 6 — Slide Metal Clip onto Accessory Tray NOTE:
It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports. • Insert the carriage bolt through the holes from the outside of the unit and attach a plastic knob from the inside of the unit. Tighten by hand (Figure 3). Figure 3 — Secure Handle Add Engine Oil IMPORTANT: Any attempt to crank or start the engine before it has been properly serviced with the recommended oil may result in an engine failure. • Place pressure washer on a level surface. • Insert the “J” hook into the second from the left slot in • Refer to the engine owners manual to add recommended the accessory tray (Figure 4). oil to engine.
Figure 4 — Place “J” Hook on Accessory Tray NOTE: Check oil often during engine break–in. Refer to engine owner’s manual for recommendations. Add Gasoline WARNING! Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do Not smoke when filling fuel tank. WARNING! Never fill fuel tank completely full. • Pinch the chemical hose that comes out of a hole in the Provide space for fuel expansion. Wipe away any unit’s base and slide it into the metal clip, as shown in fuel spillage from engine and equipment before Figure 5. starting.
Figure 5 — Slide Chemical Hose into Metal Clip Figure 2 — Attach Handle to B ase Handle Align Holes Handle Supports Figure 6 — Slide Metal Clip onto Accessory Tray Figure 3 — Secure Handle Figure 4 — Place “J” Hook on Accessory Tray