AND ADJUSTMENTS FRONT-TO-BACK ADJUSTMENT (See Figs., 2t and 22) IMPORTANT: DECK MUST BE LEVEL SIDE.TO-SIDE. 1F THE FOLLOWING FRONT-TO-BACK ADJUSTMENT tS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" on page 3 of this manual). Iftires are over or'underinflated, you will not properly adjust your mower. SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20) o Raise mower to its highest position.
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower' is in its highest position, Check adjustment on right side of tractor, Measure dis- tance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown. ° Before making any necessary adjustments, check that both front links are equal in length., Both links should be approximately 10-3/8'L - If links are not equal in length, adjust one link to same length as other link. To lower front of mower loosen nut "E" on both front links an equal number of turns.
When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links. To raise front of mower, loosen nut"F' from trunnion on both front links. Tighten nut "E" on both front links an equal number of turns. When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut"F" against trunnion on both front links, Recheck side-to-side adjustment. At the midpoint of both sides of mower, measure height " " "on from bottom edge of mower to ground_ D_stance A ' " " 1 4" both stdes of mower should be the same or within / of each other - If adjustment is necessary, make adjustment on one side of mower only.
To raise one side of mower, tighten lift link adjustment nut on that side. To lower one side of mower, loosen lift link adjustment nut on that side° NOTE: Each full turn of adjustment nut will change mower height about 1/8'L Recheck measurements after adjusting. BOTTOM EDGE BOTTOM EDGE OF MOWER TO OF MOWER TO GROUND GROUND A GROUND LINE oo, "', MANDREL FIG. 19 SUSPENSION ARM FIG. 21 BOTH FRONTLINKS MUST BE EQUAL IN LENGTH LIFT LINK ADJUSTMENT NUT FIG. 20 NUT NUT "F" __:___" 22 FRONT LINKS TRUNNION FIG, 22