_u_/iJ/i , ii i,i, ill , ,u, ii illl ii illlUllllll Jllnll IlUllll ........ iilllllllullull ASSEMBLY HOW TO SET UP YOUR TRACTOR CONNECT BATTERY (See Figs. 2 and 3) SEAT PAN CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. BOX DOOR Positive terminal must be connected first to prevent sparking from acciden- t!! gr°unding; ..... ........... Remove cardboard packing from seat pan and lift seat pan to raised position. ° Open battery box door° Remove terminal protective caps and discard. FIG. 3 INSTALL SEAT (See Fig.
4) If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amp& First connect RED batter,] cable to positive (+) terminal with hex bolt, fiat washer, lock washer and hex nut as shown. Tighten securely. Connect BLACK grounding cable to negative (-) termi- nal with remaining hex bolt, fiat washer, lock washer and hex nut° Tighten securely° Adjust seat before tightening adjustment bolt. Remove cardboard packing on seat pan_ Place seat on seat pan and assemble shoulder bolt. Assemble adjustment bolt, lockwasherandflatwasher Ioosefy. Do not tighten. ° Tighten shoulder bolt securely.
° Lower seat into operating position and sit on seat. ° Close battery box door. = Slide seat until a comfortable position is reached which aUows you to press clutch/brake pedal all the way down. Open battery box door for: ° Inspection for secure connections (to tighten hard- ware), , Get off seat without moving its adjusted position. Raise seat and tighten adjustment bolt securely. ° Inspection for corrosion. Testing batter,]. ° Jumping (if required). SEAT Periodic charging. SEAT PAN DISCARD TERMINAL PROTECTIVE SHOULDER BOLT POSITIVE (RED) CABLE CAPS HEX NUT LOCK WASHER FLAT WASHER i HEX BOLT FLAT WASHER ADJUSTMENT WASHER BOLT FIG. 4 NEGATIVE (BLACK) CABLE FIG. 2 8