Cam shafts To remove the cam shafts 1 Remove the HVPS. 2 Remove the left side cover. 3 Remove the ITB drawer. 4 Open the drum drawer and remove the drum cartridge. 5 Remove the appropriate clutch or gear on the left side. 6 Using needle-nose pliers, remove the e-rings from each end of the shaft being removed. 7 Remove the bushings. 8 Remove the shaft. Note If the shaft is undamaged, then only the cams need to be replaced. Remove the screw from the cam and replace only the cam. Figure 6-73 Cam shaft removal and replacement 208 Removal and replacement C7085-90921