Tools G Phillips #2 magnetized screwdriver with 6-inch shaft G Flat-blade screwdriver with 6-inch shaft G Needle-nose pliers G Penlight Screws Used in the Printer All screws used in the printer are Phillips head, which require a Phillips screwdriver. The following figure shows the difference between a Phillips and a Posidriv screwdriver. Note that the Phillips tip has more beveled surfaces. CAUTION Using a Posidriv screwdriver will damage the screw heads. Use Phillips only. Phillips Posidriv Figure 6-1 Comparing Phillips and Posidriv Screwdrivers Table 6-1 on page 6-4 describes the screws used in the printer and provides guidelines to help determine where each type of screw is used.
The screws can vary in length depending on the thickness of the material being fastened. Always note where each type of screw is located and replace each one into its original location. Removal and Replacement Strategy 6-3