Gear Train Toner Cartridge Drive Arm Step 4 Figure 6-37 Removing the Gear Train 1 Remove the following covers (starting on page 6-6): Top Cover, Front Right Side Cover, Rear Cover/Rear Output Bin, and Tray 1. Remove the Right Side Toner Cartridge Guide (page 6-33), the Registration Assembly (page 6-34), the Formatter Cage Assembly (page 6-20), and the Formatter Pan (page 6-39). The Gear Train is on the right side of the printer. 2 If the Registration Assembly has not already been removed, take out the rearmost silver screw under the green handle (page 6-35). 3 Remove the 8 black self-tapping screws. 4 Pull the Ribbon Cable Assembly outward (off the pin), then down, out of the way.
5 Remove any remaining wires from the white plastic guide. 6 Slide out the Gear Train. Note When you reinstall the Gear Train, slide the top in first and then push the bottom in. 6-40 Removing and Replacing Parts