Table 16. Alert and warning messages (continued) Message Possible causes Solutions ### Is Empty [Enter] To Add The one-touch key or speed-dial code has not been programmed and therefore cannot be added to a group. Press menu/enter to program the one- touch or speed-dial. If you want to program a group-dial, press cancel and use the control panel menu to create a new group. Press cancel if you do not want to program the one-touch or speed- dial. ###: [Group Name] Phbook/SpeedDial The product is waiting for you to press a programmed one-touch key or enter a speed-dial code to a group-dial code. Begin adding fax numbers to the group- dial code.
See “Programming group-dial codes” in the User Guide on the product CD. Canceled Copy. Clear Document The cancel key was pressed to cancel the current job while pages were feeding from the document feeder. The cancel process will not automatically clear the document feeder. Pull the document release door open, remove the jammed item, and close the door. Then, clear the items in the document feeder tray and start over. Canceled Scan. Clear Document The cancel key was pressed to cancel the current job while pages were feeding from the document feeder. The cancel process will not automatically clear the document feeder.
Pull the document release door open, remove the jammed item, and close the door. Then, clear the items in the document feeder tray and start over. Canceled Send. Clear Document The cancel key was pressed to cancel the current job while pages were feeding from the document feeder tray. The cancel process will not automatically clear the document feeder. Pull the document release door open, remove the jammed item, and close the door. Then, clear the items in the document feeder tray and start over. Comm. Error Fax communication error occurred between the product and the sender or receiver.
For descriptions of communication errors see table 22, “Fax receive error codes,” on page 211, and table 23, “Fax send error codes,” on page 216. Allow the product to retry sending the fax. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. Try a different phone cord. If the error persists, check the flat flexible cable between the LIU and the formatter. Reseat or replace the cable. If the error persists, replace the LIU. Device Busy. Try Again Later The product is currently in use. Wait for the product to finish the current job. Device Error. [Enter] To Cont.
There was an internal error in the product. Press menu/enter to resume the job. EN Errors 179