Table 16. Alert and warning messages (continued) Message Possible causes Solutions Fax Recv Error An error occurred while trying to receive a fax. Ask the sender to resend the fax. Try faxing back to the sender or another fax machine. Check that the telephone cord is securely connected by unplugging and replugging the cord. Check for a dial tone on the phone line by pressing fax/send . Make sure the phone is working by disconnecting the product, plugging in a telephone to the phone line, and making a voice call. Connect the product to a different phone line. If the error persists, check the flat flexible cable between the LIU and the formatter. Reseat or replace the cable.
If the error persists, replace the LIU. Fax Send Error An error occurred while trying to send a fax. Try resending the fax. Try faxing to another fax number. Check that the telephone cord is securely connected by unplugging and replugging the cord. Check for a dial tone on the phone line by pressing fax/send . Make sure the phone is working by disconnecting the product, plugging in a telephone to the phone line, and making a voice call. Connect the product to a different phone line. If the error persists, check the flat flexible cable between the LIU and the formatter. Reseat or replace the cable. If the error persists, replace the LIU.
Fit to Page on Flatbed Only Fit to Page does not work when the ADF is being used. Use the flatbed or choose another reduction/enlargement setting. Group Dial Not Allowed In Group The speed-dial code you entered is programmed for a group. Adding a group-dial to another group-dial is not allowed. Enter one-touch keys (programmed as an individual speed dial) or speed-dial codes to a group-dial Group Is Full. [Fax] To Start The maximum number of fax numbers that can be added to an ad hoc group is 20. Resend to the ad hoc group using less fax numbers. Invalid Date An invalid date was entered, such as June 35. Reenter the date. Invalid Entry Invalid data or response. Correct the entry. Memory Low.
Press [Cancel] The product memory has been almost completely filled. Allow the product to finish the job or press cancel to cancel the job. EN Errors 181