Table 16. Alert and warning messages (continued) Message Possible causes Solutions No Fax Answer. Redial Pending You tried to send a fax, but the receiving fax line did not answer. The product attempts to redial after a few minutes. Allow the product to retry sending the fax. Call the recipient to ensure that the fax machine is on and ready. Check that you are dialing the correct fax number. Check that the Redial-No Answer option is enabled. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. Try a different phone cord.
If the error persists, check the flat flexible cable between the LIU and the formatter. Reseat or replace the cable. If the error persists, replace the LIU. No Fax Detected The product answered the incoming call but did not detect that a fax machine was calling. Allow the product to retry receiving the fax. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. Try a different phone cord. If the error persists, check the flat flexible cable between the LIU and the formatter. Reseat or replace the cable. If the error persists, replace the LIU.
No Fax Pages To Reprint The product attempted to execute “Reprint Last Fax” when nothing was in memory. Receive a fax before attempting to use this option. Not Enough Memory.Try Later There is not enough memory to start a new job. Wait until the current job is finished before starting a new job. Out of Range An invalid number was entered. Correct the entry. Printer Jam. Clear Paper Path The product has detected a jam. Clear the jam. The job should continue to print. If it does not, try reprinting the job. If media jams frequently, see Chapter 3, “Maintenance.” Printer Mispick [Enter]To Resume The print engine has failed to pick up a piece of media.
Reload the paper in the paper input tray and press menu/enter to continue the job. If the error persists, replace the printer pickup roller. Printer Tray Is Empty.Add Paper The paper input tray is empty. Load media. If media is already loaded, remove it. Check for and remove any jam, and then reload the stack of media in the paper input tray. EN Errors 183