Table 10. Control panel error messages (continued) Message Cause Solution No Fax Detected The product answered the incoming call but did not detect that a fax machine was calling. Allow the product to retry receiving the fax. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See chapter 6, “Troubleshooting.” No Fax Pages To Reprint The product attempted to execute “Reprint Last Fax” when nothing was in memory. Receive a fax before attempting to use this option. Not Enough Memory.Try Later There is not enough memory to start a new job.
Wait until the current job is finished before starting a new job. Out of Range An invalid number was entered. Correct the entry. Printer Jam. Clear Paper Path The product has detected that a jam has occurred. Clear the jam. The job should continue to print. If it does not, try reprinting the job. Printer Mispick [Enter]To Resume The print engine has failed to pick up a piece of media. Reload the paper in the paper input tray and press menu/enter to continue the job. Printer Tray Is Empty.Add Paper The paper input tray is empty. Load media. If media is already loaded, remove it. Check for and remove any jam, and then reload the stack of media in the paper input tray.
Scanner Bulb Failure The scanner assembly experienced an error in scanner bulb functionality. Disconnect the power cable from the product, wait at least 30 seconds, then reconnect the power cable and wait for the product to initialize. Try another power source. If the message does not clear, see chapter 6, “Troubleshooting.” Scanner Reserved For PC Scan The product is being used to create a scan by a computer. Wait until the PC scan has finished, or cancel the scan from the computer software, or press cancel . Scanning Error. Cannot Connect The product cannot transmit scan information to a computer. Check the connection cable and try the scan again.
Settings Cleared The product has cleared job settings. Reenter any desired job settings. Time/Date is in Past. Try Again Invalid date or time entry. Enter the correct time or date. 44 Chapter 2 - Operation EN