Adaptive cruise control system ACC ACC uses the front millimeter-wave radar at the grille of front bumper to detect the relative distance and speed of the vehicle and the vehicle in front. It actively controls the speed of the vehicle to achieve the purpose of automatic car following cruise. When there is a target vehicle in front, as long as the vehicle speed is lower than 150 km/h, the ACC can be activated. ● Override mode control: When ACC is activated, if overtaking is required, driver could step on the accelerator and the system enters into override mode. Release the accelerator within 15 minutes, the vehicle will return to the target speed. 1 ● Exit ACC:
If working conditions for ACC cannot be fulfilled, such as it is not at F gear, or doors are open, ACC will be automatically turned off in 3 ways: fast exit, slow comfort exit or brake continuance mode exit. 2 3 ● Driver takeover request: When ACC cannot sustain the minimum safety distance, dashboard reminds driver to step on brake. Warning • Do not use ACC on curved or slippery roads, or when driving at steady speed is unsafe. • ACC is only driving assistance system and cannot replace driver. You must always maintain control of the vehicle, drive cautiously, obey speed limit, traffic rules, and take full responsibility for driving.
• You are always responsible for driving the vehicle in a safe manner and complying with the marked speed limits. 4 ACC ● Electronic parking (EPB) is in released state. ● The vehicle is in the forward gear (D gear) 5 ● The car didn't slip behind. ● The four doors of the vehicle are closed. ● The main driver's seat belt is fastened ● The ESC off icon on dashboard is not lit. 6 ● Follow control: When ACC is active, and the state of front vehicle has comparatively large effects on your vehicle, the relative distance could be kept as set by the driver. Once front vehicle stops, your car stops. ● The Steep descent indicator on the dashboard does not lit.
● ESC system is not active 7 ● Speed ≤ 150km / h ● The vehicle is operated on normal mode (non-sand/mud, etc.) ● Start control: ACC could decrease speed of vehicle to complete stop. If the front vehicle starts in 3s, then ACC will automatically start. If the vehicle is stopped in 3s~5min, vehicle could be started when driver steps accelerator or operate RES+ pole. ● When the vehicle speed is 0 km/h, brake pedal is stepped on; or when speed is more than 0 km/h, brake is not stepped on. 8 ● Curve - speed control: When ACC is in working state, and the vehicle is on curve road, ACC will properly decrease the speed to ensure the vehicle pass the curve stably.
● There is no malfunction indicator of vehicle network communication on dashboard. 9 ● Auto Hold function is not active ● T he AEB function is not activated 10 11