Chapter 5 Parameters List SI30 Solar Pump Inverter Manual Stands for parameters can modify during running Stands for parameters can’t modify during running “Ч”： Stands for parameter read only, can’t modify Stands for factory parameters, only for factory Stands for relative with AC drive models Basic Function Parameter 20 Funct ion code Function name Setting range and definition Default setting property Comm.
Add F0.00 Control mode 1：AM linear VF control without PG 6：Voltage vector control without PG for PMSM 1 〇 0x000 F0.02 Running control mode 0：Key board control 1：Terminal control 0 〇 0x002 F0.03 Main frequency source X reference 0：digital reference of keyboard 1：Potentiometer of key board 8：PID control reference 0 〇 0x003 F0.08 Digital frequency reference 0.00～maximum frequency 50.00Hz ● 0x008 F0.09 Maximum frequency 0.00～320.00Hz 50.00Hz 〇 0x009 F0.11 Upper limit frequency Lower limit frequency～Maximum frequency 50.00Hz ● 0x00B F0.12 Lower limit frequency 0.00~Upper limit frequency 0.00Hz ● 0x00C F0.14 Acceleration time 1 0.01～650.00s model set ● 0x00E F0.15 Deceleration time 1 0.01～650.00s model set ● 0x00F F0.16 Rotation direction 0：consistent 1：Runs in reverse 2：Forbidden reverse 0 ● 0x010 F0.17 Carrier frequency 0.6～15.0kHz model set ● 0x011 F0.19 Factory setting 0：No operation 1：Restore to default(motor parameters don’t restore) 2：Clear fault record 3：Restore to default(motor parameters restore) 0 〇 0x013