Contents Connections Playback Settings Tips Appendix 3 Connect the Sound calibration microphone to the SETUP MIC jack of this unit. 5 Select “Start”, then press ENTER. Audyssey ® Setup can also make the following settings. 0 Amp Assign The signals output from the SURROUND BACK speaker terminals can be switched in accordance with your speaker environment. (“Amp Assign” ( v p. 174)) 0 Channel Select If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers. When the Sound calibration microphone is connected, the following screen is displayed.
0 Dolby Sp.Setup Set the distance between the Dolby Atmos Enabled speaker and the ceiling. This can be set when “Assign Mode” is set to “Front Dolby” or “Surround Dolby” in the “Amp Assign” settings. ( v p. 174) Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone and mic stand. Audyssey Setup Audyssey Setup Set the following items if necessary. Channel Select Amp Assign 4 Select “Next”, then press ENTER. Next Back Dolby Sp.Setup Start Back Front panel Display Rear panel 167 Remote Index