Contents Connections Playback Settings Tips Appendix 13 When the analysis and storage ends, unplug the Sound calibration microphone from the SETUP MIC jack on the main unit and then press “Next”. 14 Select “Details” and press ENTER to verify the measurement results. 0 Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers. Now Analyzing and correcting the your room data. Audyssey Setup NOTE 0 Do not change the speaker connection or subwoofer volume after Audyssey ® Setup. If these are changed, run Audyssey ® Setup again in order to configure the optimum equalizer settings.
Analyzing room data Back Next Front panel Display Rear panel 171 Remote Index