CAR813 Preparation Preparing for Installation Installation Package Contents Before You Begin 1.Main Unit 2.Mounting Sleeve for 1 DIN 3.Release Keys 4.Screw Kit 5.Chassis sleeve for 2 DIN install Before You Begin 6.Trim Ring 7.Wiring Harness 8.Microphone • Consult a qualified technician for instructions. We always recommend professional installation. • Disconnect the negative battery terminal. • Remove trim ring from unit (if installed). • Insert the removal keys, and remove the mounting sleeve from the receiver. 9.GPS Antenna (for CarPlay and Android Auto only) Installation Guide Note:
Most vehicles require an installation kit, wiring harness and/or antenna adapter (all sold separately) to properly install the head unit in the vehicle. Install Mounting Sleeve and Trim Ring Step #1 Connecting the LCD to the Chassis Removing the LCD from the Chassis Step #2 1) Install the mounting sleeve into a dash kit (sold separately) or dash opening, bending the tabs to secure the mounting sleeve. 2) Connect the wiring harness, microphone and antenna to the chassis To connect the LCD to the unit, carefully push the LCD connector into the receiver's chassis until you hear a click as shown below. 1. Hold down the two release buttons of the radio.
3) Snap trim ring into place making sure the notched area is on the bottom. 4) Slide the receiver into the mounting sleeve to secure. 2. Gently pull the display panel forward Installing the 2-DIN Chassis Sleeve Install Mounting Side Brackets Installation Complete Step #1 Step #2 Step #3 Attach the 2-DIN chassis sleeve using (4) M2.5*4 screws Mounting brackets shown below or optional vehicle mounting kit are not included 2-DIN Chassis Sleeve A Install the 2-DIN mounting chassis sleeve to the top of the chassis (shown above) or to the bottom of the chassis (shown below). OR B choice of mounting option as shown in Step #1 to the left.
5 1 2 3 4 5 MFRlooauut nnHdtei n Hagde aSSdcc rrSeecwwre fMwor5 M *265D *8IN 6p c8Bspr ca scket M2.5*4 5PCS 6 7 8 9 Install the m radio or to t ounting brackets to the chassis of the he 2-DIN chassis sleeve depending on