en Rinse aid system Regeneration of the water softening system Rinse aid system Rinse aid system In order to obtain fault-free function of the water softening system, the appli- ance performs regeneration of the water softening system at regular in- tervals. Regeneration of the water softening system takes place before the end of the main rinse cycle in all pro- grammes. It will increase the run time and consumption values, e.g. water and electricity. Rinse aid system You can use the rinse aid system and rinse aid to get tableware and glasses rinsed perfectly without marks. Rinse aid For optimum drying results, use rinse aid. Only use rinse aid for domestic dish- washers.
Overview of consumption values with regeneration the water softening system Here you can find an overview of the maximum additional run time and consumption values during regenera- tion of the water softening system. Adding rinse aid If the rinse aid refill indicator lights up, top up with rinse aid. Only use rinse aid for domestic dishwashers. 1. Press the catch on the lid of the dispenser for rinse aid and lift .
Regeneration of the water softening system after x rinse cycles 6 Additional run time in minutes 6 Additional water consumption in litres 5 Additional power consumption in kWh 0.05 The consumption values specified are laboratory measurements determ- ined in accordance with the currently applicable standard and using the Eco 50° programme and the factory value of the water hardness is set to 16 - 20°E. 2. Add rinse aid up to the max mark. max 3. If rinse aid spills out, remove it from the tub. 26 2 1