MIL MIL-HDBK-683(AT) — MIL-HDBK-683(AT) Statistical Process Control (SPC) Handbook - Implementation & Evaluation PDF (EN)

Downloaded from https://www.everyspec.com !.. rfIHmBK-683(AT) MAPTER4 REQUIME4RNTS FOR AN SPC PROGRAM IMPxAnmmTxxe 4-1 ~- ~is Cm?t= conta~m* requimaenta for the bplaentatim of an SPc ~. 4-2 ~. The lnvolvemmt of upper menagemnt insPcreguire8 thatliheya18t Understand thepmgram in order to8upport, partici~te in, and comnit ~lves to this -gram. Ckce they understand what SPC ia, i- benefit, what to expect, how to impl~nt it, and how to auatain it, then they can make the connitment. This comdtment ti mt a me time thing, it-s a continuous act. The ~itmnt is to tranefom their vision to reality.

They uxiar8tand that comltment is to provide contlmu0u8 ~- ~ wicimti- ** the inlplementationPhaee and * Uulstaining -- This proceaa can take plaoe in a eemimar for executives. Then each executive can partici~te in a similar ecminar with hia etaff, and cascade this understanding, cmmitment, support and participation throughout his staff and the organization.

4.3 Onoe the organization is pre~ for the Challenge of implementation, ed&ation must be pmYvided in baeic atatistica, Ihtograa, pare-toanalyais, process control charte (including analy8is of caltrol charts), il18pection/testcapability Utudiee and process capability studies (*w chapter 2 for definitione of these tenne, especially the power of the process capability study). 4.4 SEC without problem-solving techniques yiolda a syndrow caliOd “Wall Papering”’. This syndrome la evidenoad by tha posting of control charts with many polnta out-of~tml and minimal action taken to bring the proce88 back in-control.

Althwgh thare are several pmbl~ eolvi.ngteolmigues available, each key element of the probla statement muet be pre~nt before any one of these technigue8 can be G pplied. For th$u purpose, a pzmblem ia a deviation from a standard or desired level of performance for which the oause IS unknown and a resolution is required. There are aix problem solving techniques which are: a. RnHlta Log b. Diagnostic PrOoeM Audits c. Cau8e and Effect Diagram d. Cauee Andytsie e. Design of Kxperimente f. Failure Mode and Effects Analysis (FMRA). 8 21